Để lại lời nhắn
Chúng tôi sẽ gọi lại cho bạn sớm!
Chúng tôi sẽ gọi lại cho bạn sớm!
Để lại lời nhắn
Chúng tôi sẽ gọi lại cho bạn sớm!
—— Moyo
—— Octavio
—— Cristian
—— Spence
—— Samuel
—— Ali
1. The thickness of the profile is mainly based on the thickness of the floor concrete and the spacing of the secondary beams. 1. Độ dày của biên dạng chủ yếu dựa trên độ dày của bê tông sàn và khoảng cách của dầm phụ. The calculation method is very technical. Phương pháp tính toán rất kỹ thuật. It is calculated based on the relevant data such as the section modulus and section moment of inertia of the floor slab. Nó được tính toán dựa trên các dữ liệu liên quan như mô đun tiết diện và mô men quán tính của bản sàn.
2. The profile is made of cold-rolled steel plate (coil). 2. Hồ sơ được làm bằng thép tấm cán nguội (cuộn). The common specifications of the thickness of the steel plate are 0.75mm, 1.0mm and 1.2mm. Các thông số kỹ thuật phổ biến về độ dày của tấm thép là 0,75mm, 1,0mm và 1,2mm. When the thickness of the steel plate is greater than 1.2mm, the forming is difficult. Khi độ dày của tấm thép lớn hơn 1,2mm, việc tạo hình rất khó khăn. The main problem is that the stud cannot be penetrated. Vấn đề chính là stud không thể bị xuyên thủng. The profiled steel plate and the steel beam are firmly connected, so it is recommended that the floor support plate thickness should not be greater than 1.5mm. Các tấm thép định hình và dầm thép được kết nối chắc chắn, do đó, độ dày của tấm đỡ sàn không được lớn hơn 1,5mm.